Passport Holder Assembly Instructions – Artizeecrafts

Passport Holder Assembly Instructions

Passport Holder with Tab Closure

1. Get your cut pieces ready
2. Install the plastic snap buttons to the left side of the passport holder cover.
3. Put the left side piece to the back of the passport cover then follow the arrow direction to glue it in place.
4. Glue the right piece to another side.
4. Install the plastic snap buttons to the tab to finish.

A Little Tip

You can always choose to sew the passport holder If you decide to sew it, the steps are the same but make sure you sew around the holder to have a clean look. Then follow step 4 to complete the project.

If you want to get more help on how to install plastic snap button, you can go to my channel. 

Passport Holder with or without Elastic Closure

1. Get your cut pieces ready

2. Cut the fold elastic about 6 1/2” long. Place it about 1/2” from the edge of the compartment

3. Glue both ends to the back of passport compartment.

4. Glue the right piece to another side. Viola! The passport vaccination holder is done!

If you want a PDF assembly instructions, please click HERE.

Leave a comment

Please note, comments must be approved before they are published